E-Pos 1000 (P4) User Manual download pdf (Page 39)

SYSTEM HALTED, (CTRL-ALT-DEL) TO REBOOT ...

Indicates the present boot attempt has been aborted and the system must be

rebooted. Press and hold down the CTRL and ALT keys and press DEL.

Wrong Board In Slot

PLEASE RUN EISA CONFIGURATION UTILITY

The board ID does not match the ID stored in the EISA non-volatile memory.

NOTE: When this error appears, the

system will boot in ISA mode, which

allows you to run the EISA

Configuration Utility.

FLOPPY DISK(S) fail (80) o Unable to reset floppy subsystem.

FLOPPY DISK(S) fail (40) o Floppy Type mismatch.

Hard Disk(s) fail (80) o HDD reset failed

Hard Disk(s) fail (40) o HDD controller diagnostics failed.

Hard Disk(s) fail (20) o HDD initialization error.

Hard Disk(s) fail (10) o Unable to recalibrate fixed disk.

Hard Disk(s) fail (08) o Sector Verify failed.

Keyboard is locked out - Unlock the key.

BIOS detect the keyboard is locked. P17 of keyboard controller is pulled low.

Keyboard error or no keyboard present.

Cannot initialize the keyboard. Make sure the keyboard is attached correctly and

no keys are being pressed during the boot.

Manufacturing POST loop.

System will repeat POST procedure infinitely while the P15 of keyboard controller

is pull low. This is also used for M/B burn in test.

BIOS ROM checksum error - System halted.

The checksum of ROM address F0000H-FFFFFH is bad.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 61 62

No comments

E-Pos 1000 (P4) User Manual Page 39