E-Pos 1000 (P4) User Manual download pdf (Page 16)

Quick Power On Self Test

This category speeds up the Power On Self Test (POST). The default is Enabled.

Enabled :This setting will shorten or skip of the items checked during POST.

Disabled :Normal POST.

First

The BIOS attempts to load the operating system from the devices in the se-quence

selected in these items.

Options:Floppy,LS120,HDD-0,SCSI,CDROM,HDD-1,HDD-2,HDD-3,

ZIP100,USB-FDD,USB-ZIP,USB-CDROM,USB-HDD,LAN,Disabled.

Boot Other Device

When enabled, the system searches all other possible locations for an operating

system if it fails to find one in the devices specified under the first, second , and

third boot devices. The default is Enabled.

Options: Enabled , Disabled.

Swap Floppy Drive

This will swap your physical drive letters A&B if you are using two floppy disks.

The default is Disabled.

Enabled : Floppy A&B will be swapped under the O/S.

Disabled: Floppy A&B will be not swapped.

Boot Up Floppy Seek

If this item is enabled, it checks the size of the floppy disk drives at start-up time.

You don t need to enable this item unless you have a legacy diskette drive with

360K capacity. The default is Disabled.

Options : Enabled , Disabled.

Boot Up NumLock Status

This controls the state of the NumLock key when the system boots. The default is

On.

On : The keypad acts as a 10-key pad.

Off : The keypad acts like cursor keys.

Gate A20 Option

This refers to the way the system addresses memory above 1 MB (extended

memory ). The default is Normal.

Normal : The A20 signal is controlled by the keyboard controller or chipset

hardware.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 61 62

No comments

E-Pos 1000 (P4) User Manual Page 16