E-Pos 1000 (P4) User Manual download pdf (Page 10)

10

31. Power1=ATX Power connector

32. CN6 = ATX power connector for +12V

33. IDE1 = Primary IDE Connector

34. IDE2 = Secondary IDE Connector

35. FDD = Floppy Disk Connector

36. BAT1 = CMOS Battery socket

37. VGA = VGA monitor connector

38. LPT1 = Printer connector

39. USB1 = 2 x USB 2.0 connector

40. PWR_SW = Power switch connector for front bezel

41. PWRLED = Power LED connector for front bezel

42. RST_SW = Reset switch connector for front bezel

43. LANLED = Lan LED connector for front bezel

44. IDELED = HDD LED connector for front bezel

Chapter 6

AWARD BIOS SETUP

6.1 BIOS Introduction

The Award BIOS (Basic Input/Output System) installed in your computer system’s

ROM supports Intel Pentium 4 processors. The BIOS provides critical low-level

support for a standard device such as disk drives, serial ports and parallel ports. It

also adds virus and password protection as well as special support for detailed fine-

tuning of the chipset controlling the entire system.

6.2 BIOS Setup

The Award BIOS provides a Setup utility program for specifying the system

configurations and settings. The BIOS ROM of the system stores the Setup utility.

When you turn on the computer, the Award BIOS is immediately activated.

Pressing the <Del> key immediately allows you to enter the Setup utility. If you are

a little bit late pressing the <Del> key, POST (Power On Self Test) will continue

with its test routines, thus preventing you from invoking the Setup. If you still wish

to enter Setup, restart the system by pressing the ”Reset” button or simultaneously

pressing the <Ctrl>, <Alt> and <Delete> keys. You can also restart by turning the

system Off and back On again. The following message will appear on the screen:

Press <DEL> to Enter Setup

In general, you press the arrow keys to highlight items, <Enter> to select, the

E-Pos 1000 (P4) User Manual Page 10